Install HighAsCG from the live USB stick onto an internal SSD/HDD/NVMe using the graphical Calamares wizard.
Full guide (partition layouts, bios_grub, UEFI ESP, troubleshooting): CALAMARES_INSTALL_TO_DISK.md
sudo -n /usr/local/bin/launch-calamares.shlsblk -o NAME,TYPE,SIZE,MODEL,TRAN,FSTYPE
Install on the internal drive (Kingston, NVMe, …). Do not install on the USB stick or its exFAT partition (HIGHASCGEXF, often sda3).
CSM (Compatibility Support Module / Legacy boot) makes the stick boot in BIOS mode. That often causes bootloader could not be installed (error 1) on HighAsCG ISOs.
[ -d /sys/firmware/efi ] && echo UEFIThen use Erase disk below — no manual bios_grub needed.
Erase disk and install on the internal drive. Swap: none.
| Size | FS | Mount | Flags |
|---|---|---|---|
| ≥ 300 MiB | fat32 | /boot/efi |
boot + esp |
| rest | ext4 | / |
— |
GPT partition table. This layout (with CSM disabled) fixed bootloader install on several playout PCs.
| Size | FS | Mount | Flags |
|---|---|---|---|
| 1–2 MiB | unformatted | — | bios_grub |
| rest | ext4 | / |
— |
The bios_grub slice must stay unformatted — no ext4 on that 1–2 MiB partition. Without it, GRUB/partition steps often fail on BIOS machines.
| Message | Likely fix |
|---|---|
| Failed to create partition | Wrong disk; add ESP or bios_grub; try Erase |
| rsync error 11 / unpackfs failed | / too small or wrong FS; not internal ext4; check dmesg |
| Bootloader could not be installed (code 1) | Disable CSM, boot USB in UEFI, fat32 /boot/efi (≥300 MiB, boot+esp) + ext4 / |
| logs-helper / external command exit 1 at end | Install often OK — remove USB and boot internal disk; run fix-calamares-shellprocess.sh on stick |
| No disk in Calamares | BIOS AHCI; run probe-internal-storage.sh --check |
Log: ~/.cache/calamares/session.log
Calamares is on the live ISO. eggs krill is on the eggs build host only, not the stick.